Dewalt Guide Rail Square Adapter - DIY Kit
Dewalt Guide Rail Square Kit
We worked with engineer Jeff Wagner to bring his rail square idea to market. The goal of this rail square adapter was to be an affordable option that will still produce accurate 90/45 degree alignment.
This is designed to work with Dewalt Guide Rails.
Our guide rail square uses the accuracy of the 90/45 degree sides on the aluminum rafter squares to achieve a true 90 and 45 degree angle. We are able to keep the costs down by using a 3D printed cam lock mechanism to secure the square against the rail. There are a total of 4 cam locks, 2 on each side so that you can use the square on either side of the guide rail.
- The guide rail square creates accurate 90 and 45 degree alignment
- The guide rail square can be used on either end of the guide rail
- Strong cam locking system to ensure snug fit to rail
- Optional Support Tab to keep the rail square flush to your workpiece
Our guide rail square adapter uses the accuracy of an Empire square and the guide rail to achieve accurate 90 degree and 45 degree alignment. The kit installs onto an Empire square within a few minutes. It uses a cam lock system to press the Empire square to the guide rail t-track, achieving a true 90 degree.
90° and 45° Alignment
The guide rail square adapter can be flipped around and used on both sides. This means that you can set up a 90 degree cut or 45 degree on the close side of your workpiece. You can also install the guide rail square on the far side of the guide rail on the opposite side of the work piece.
Optional Support Tab
The Empire square is 12" long, which means towards the end there will be minimal sagging due to the weight. This is common on all guide rail squares. We provide an optional support tab which will let the guide rail square and guide rail sit flush onto the workpiece.
- Weight: 6 oz (excluding rafter square)
- Material: HTPLA plastic
- Compatible Guide Rails: Dewalt and Powertec (Dewalt Clone)
- Compatible Rafter Squares: Empire #3990 and Empire #E3992
(2) Installation Brackets
- (4) Cam Locks
- (2) Countersunk Screws
- (2) Nylon Hex Lock Nuts
What's Included: Optional Support Tab?
(2) Installation Support Tab Brackets
(2) Support Tabs
- (1) Countersunk Screws
- (1) Nylon Hex Lock Nuts
It’s great- don’t hesitate
This is exactly what I was looking for and it works great.
I haven't used it on a project yet but I attached the kit to the square, which was easy enough to do. Putting the whole thing on the track was also simple to do and mytest cut was square. So far, so good.
This thing does the job perfectly, simply, with no fuss or complexity. The best tools are the simple tools, and the most efficient ones are the ones that do a single job. This square is absolutely perfect in that regard. It claims to hold the track at 90* to the reference edge and with the additional stabilizer, to stabilize the work piece. It does **EXACTLY** that, again, with no complexity or frills. Every tool should be this good and this elegant. Well done.
Tool Theory’s kit is great; the Empire square no so much. I had to do some sanding on the square to make it register as square.