Kreg Guide Rail Index Set
Details
Setup and clean up are both simple and only takes a few seconds. The Index Set comes in many different variants to fit your needs. This will fit perfectly into your guide rail slots while still moving freely to allow easy adjustments. The fit may be very snug when you receive them, but they will loosen up after a couple uses.
- Provides a secure index location for your guide rails
- Many applications such as domino joiners, biscuit joiners, dowels, routing and track saws
- Can be utilized for a guide stop or limit stop
- Multiple variants to fit your needs
Features
Indexing: The index stops will allow you to set up indexing locations on the guide rail. This will allow you to cut joinery in a straight line. You can then transfer the guide rail to another workpiece and have the same indexing locations set up for your second or third workpiece without the need to setup and measure again.
Limit Stop: The index stops can also be used as limit stops. You can use the limit stops with the guide rail to route a straight line with positive start and stops. The limit stops can also be used with track saws.
End Stop: The end stops will allow you to reference the end of the workpiece. This way when you transfer the guide rail to a new workpiece, the index stops are aligned in the same locations as the old workpiece. This is a crucial part for being able to make repeatable cuts or for joinery.
Materials: Made out of strong PLA plastic, in Papillion, Nebraska.
What's Included
2 Index Stop Set
- (2) Guide Rail Index Stops
Standard Set
- (2) Guide Rail Index Stops
- (2) Guide Rail End Stops
Deluxe Set
- (4) Guide Rail Index Stops
-
(2) Guide Rail End Stops